What should I do if the checkweigher cannot weigh?

Abstract: During the long-term operation of the automatic checkweigher, various abnormal situations may occur. What should I do if the checkweigher is unable to weigh? At this time, check the weighing tray (that is, the middle section of the automatic checkweigher), check whether the gasket of the device sensor is installed and where it is installed! The following is from

During the long-term operation of the automatic checkweigher, various abnormal situations may occur. What should I do if the checkweigher is unable to weigh? At this time, check the weighing tray (that is, the middle section of the automatic checkweigher), check whether the gasket of the device sensor is installed and where it is installed!

The following are the self-checking steps of the automatic checkweigher:

① Disassemble the weighing tray

② Unscrew the protective screw of the sensor

③ Check if the gasket is installed

④ Check whether the gasket is aligned with the corresponding hole

⑤ After installing the gasket, restore the pallet. If the weighing is abnormal, you need to return to the operation interface to reset the technical parameters.

If you still cannot weigh after setting the parameters, you need to call the checkweigher supplier and the engineer will guide the installation.

Note: This usually happens when the automatic checkweigher has just entered the factory and has not been installed correctly.